Micro-mesh soft touch pad kit

Micro-mesh is a unique, cushioned abrasive consisting of silicon carbide crystal in an elastic layer on a cloth backing. Unlike standard sandpapers, Micro-mesh retains its cutting edge up to sixteen times longer, and the cutting particles are in floating suspension, allowing for smooth cuts as small as 0.001" at a time, with little heat build-up. By using the micro-mesh with soapy water, a scratch-free mirror finish can be obtained. 

Benefits of Micro-Mesh Soft Touch Pad Kit:

• Excellent for fine finishing jobs: Micro-Mesh Micro-Mesh is ideal for fine finishing jobs. Because of its ability to cut evenly and consistently, a smooth finish can be achieved on the surface of any material.
• Retains its cutting edge: Being made of silicon carbide glass,Micro-Mesh retains its cutting edge up to sixteen times longer than standard papers. 
• It can cut smoothly: The cutting particles in Micro-Mesh are in floating suspension, allowing you to make smooth cuts as small as 0.001" at a time, with little heat buildup. This means you can work with heat-sensitive materials without damaging them. You can also use kerosene as a lubricant if you're concerned about grain lifting. 
• Scratch-free finish: Using soapy water as a lubricant, micromesh can achieve a scratch-free mirror finish. This is especially useful for fine finishing work on delicate material surfaces, such as musical instruments, for example.
• Versatile: Micro-Mesh has multiple uses for repair and finishing work. In addition to being ideal for polishing frets, it can also be used for finishing touches or repairing scratches on pickguards.

How to use the Micro-Mesh Soft Finish Pad Kit?

1. Material Preparation: Make sure the surface is clean and free of any dirt. If necessary, sand the surface with low grit sandpaper to remove any imperfections.
2. Selecting the right pad: The kit includes nine pads of different grades, from 1500 to 12000. Start with the lowest grit pad and work your way up to the highest, until you have reached the desired finish.
3. Wetting the pad: It is important to use soapy water as a lubricant when working with Micro-Mesh pads. Wet the pad with water before starting to work.
4. Working the surface: Start working the surface gently, moving the pad back and forth in a circular motion. Do not press too hard, as Micro-Mesh pads are very effective and can remove material quickly.
5. Clean the surface: Clean the surface with soap and water to remove any residue. If desired, you can apply an additional coat of wax or oil to protect the surface.