Blush Remover Nitorlack

Blush Remover Nitorlack

The Nitorlack Blush Remover is the technical solution for eliminating the milky white blushing that appears during lacquering with nitrocellulose or polyurethane, usually caused by ambient moisture trapped in the lacquer film.

Unlike a conventional solvent, its formula reopens the surface of the lacquer just enough to allow the moisture to escape, restoring transparency and gloss without the need to sand or start over. It leaves no residue or marks after evaporation. It can be applied both while the lacquer is still wet or once it has dried on the surface.

Note: Do not use on untreated wood. Designed exclusively to act on layers of solvent-based lacquer or varnish.

Instructions for use

1. Shake the container well for 20-30 seconds.
2. Spray evenly at 15-25 cm over the affected area.
3. The blushing disappears as the lacquer levels out. Allow to dry completely.
4. If the blushing does not fully disappear, repeat the process.
5. Optional: once dry, even out the gloss with a microfibre cloth.

Technical specifications

• Use: Blushing removal on solvent-based lacquer
• Compatibility: Nitrocellulose and two-component polyurethane
• Application: Wet or surface-dry lacquer
• Residue: Leaves no residue or marks